|
 |
Hard drive profile
 |
|||||||
| Date added: | 2014-07-11 | Posted by: | diamond-optic | ||||
| Brand: | Seagate | Firmware: | 3.AAE | ||||
| Model number: | ST3750640AS | Manufacture date: | N/A | ||||
| Model name / serie: | Barracuda 7200-10 | Buffersize: | 16 MB | ||||
| Drive size: | 750 GB | RPM: | 7200 | ||||
| XBOX version: | v1.0 | Progam(s): | Chimp 2.6 | ||||
 Yes |
|||||||
| Additional notes: | Report this entry - Edit | ||||||
| Cloned from a nearly full stock 8gb HDD in about 10 minutes using Chimp 2.6... Using a pretty generic SATA -> IDE bridge, with the bridge jumper set to slave during cloning and then master with just the sata drive hooked up afterwards. Xbox would not boot from the new drive with the stock IDE cable, but it works fine after switching to an 80 wire IDE cable. Drive gets pretty warm to the touch while just idling in XBMC, but HDD temp reports as 37C, unsure about temps during gaming/heavy load. After formatting, reports 691GB F: partition |
|||||||